jeffquitney
patreon
The Molten-Salt Reactor Experiment ~ 1970 Oak Ridge National Laboratory
🕑 Added 2021-01-13 20:55:34 +0000 UTCmore at http://quickfound.net/
Originally a public domain film, slightly cropped to remove uneven edges, with the aspect ratio corrected, and one-pass brightness-contrast-color correction & mild video noise reduction applied.
The soundtrack was also processed with volume normalization, noise reduction, clipping reduction, and/or equalization (the resulting sound, though not perfect, is far less noisy than the original).
https://en.wikipedia.org/wiki/Molten-Salt_Reactor_Experiment
Wikipedia license: http://creativecommons.org/licenses/by-sa/3.0/
The Molten-Salt Reactor Experiment (MSRE) was an experimental molten salt reactor at the Oak Ridge National Laboratory (ORNL) researching this technology through the 1960s; constructed by 1964, it went critical in 1965 and was operated until 1969.
The MSRE was a 7.4 MWth test reactor simulating the neutronic "kernel" of a type of inherently safer epithermal thorium breeder reactor called the liquid fluoride thorium reactor. It primarily used two fuels: first uranium-235 and later uranium-233. The latter 233UF4 was the result of breeding from thorium in other reactors. Since this was an engineering test, the large, expensive breeding blanket of thorium salt was omitted in favor of neutron measurements.
In the MSRE, the heat from the reactor core was shed via a cooling system using air blown over radiators. It is thought similar reactors could power high-efficiency heat engines such as closed-cycle gas turbines.
The MSRE's piping, core vat and structural components were made from Hastelloy-N and its moderator was a pyrolytic graphite core. The fuel for the MSRE was LiF-BeF2-ZrF4-UF4 (65-29-5-1), the graphite core moderated it, and its secondary coolant was FLiBe (2LiF-BeF2), it operated as hot as 650 °C and operated for the equivalent of about 1.5 years of full power operation.
The result promised to be a simple, reliable reactor. The purpose of the Molten-Salt Reactor Experiment was to demonstrate that some key features of the proposed molten-salt power reactors could be embodied in a practical reactor that could be operated safely and reliably and be maintained without excessive difficulty. For simplicity, it was to be a fairly small, one-fluid (i.e. non-breeding) reactor operating at 10 MWth or less, with heat rejection to the air via a secondary (fuel-free) salt...
The MSRE operated for 5 years. The salt was loaded in 1964 and nuclear operation ended in December 1969, and all the objectives of the experiment were achieved during this period.
Checkout and prenuclear tests included 1,000 hours of circulation of flush salt and fuel carrier salt. Nuclear testing of the MSRE began in June 1965, with the addition of enriched 235U as UF4-LiF eutectic to the carrier salt to make the reactor critical. After zero-power experiments to measure rod worth and reactivity coefficients, the reactor was shut down and final preparations made for power operation. Power ascension was delayed when vapors from oil that had leaked into the fuel pump were polymerized by the radioactive offgas and plugged gas filters and valves. Maximum power, which was limited to 7.4 MW(t) by the capability of the heat-rejection system, was reached in May 1966.
After two months of high-power operation, the reactor was down for three months because of the failure of one of the main cooling blowers. Some further delays were encountered because of offgas line plugging, but by the end of 1966 most of the startup problems were behind. During the next 15 months, the reactor was critical 80% of the time, with runs of 1, 3, and 6 months that were uninterrupted by a fuel drain. By March 1968, the original objectives of the MSRE had been accomplished, and nuclear operation with 235U was concluded.
By this time, ample 233U had become available, so the MSRE program was extended to include substitution of 233U for the uranium in the fuel salt, and operation to observe the new nuclear characteristics. Using the on-site processing equipment the flush salt and fuel salt were fluorinated to recover the uranium in them as UF6. 233UF4-LiF eutectic was then added to the carrier salt, and in October 1968, the MSRE became the world's first reactor to operate on 233U.
The 233U zero-power experiments and dynamics tests confirmed the predicted neutronic characteristics. An unexpected consequence of processing the salt was that its physical properties were altered slightly so that more than the usual amount of gas was entrained from the fuel pump into the circulating loop. The circulating gas and the power fluctuations that accompanied it were eliminated by operating the fuel pump at slightly lower speed. Operation at high power for several months permitted accurate measurement of the capture-to-fission ratio, for 233U in this reactor, completing the objectives of the 233U operation...
