LO-lA59 DROID READY FOR LAUNCH !!!
🕑 Added 2022-06-27 13:13:02 +0000 UTCFinally its here, what you all have been waiting for :) that was quite an intense build, so let me walk you through it :) 1 - yes there is both functional and nonfunctional versions included in case you don't wish to mess with electronics
I have also included a little "pdf" book if you wnat to print it out to use for easier assembly :)
2 - the entire build is split up in 3 segments : top portion, lower portion and legs/stand
3- all servos are attached to the "top portion" by using either "servo cover" parts that also act as a mount and the "eye servo cover" part.
4 - all parts are connected with m3 screws or with glue
5- flap hinges use m2 screws, they are a bit smaller 6 - servo mounts also use m2 screws
7 - 5x2 mm magnets are used to switch between legs and stand
8 - version with "flap" on the lower portion is included if you want to add a on/off switch of your choice 9 - there is a space for total of 4 led's - their sizes are in the build manual
10 - the eye can move left right and has a space for led. - The eye is moved by using a 90 degree bevel gear and m3x10 mm screw - i recommend you use a bit of glue to hold it in place, the eye has to move feely left and right but not up and down
11 - the code will be worked on, for the time being i wanted to give you the files so you can start the prints. Since the code will be open source please if you beat me to it, i would kindly appreciate if you can share the code so we help the entire community with it
12 - the chassis is held up with m3 screws and nuts so you can access electronics at any time
13 - there is room inside for arduino nano, and some micro power bank and perhaps some small speaker - it is yet to be tested 14 - total of 3 servos - 2 for moving flaps individually and 1 for the eye
15 - copper wire or rods are used to help move flaps ( 2mm in thickness)
16 - you can use the same thickness rod for the antenna
I think this is it for now, as i go along i will post more photos, but everything is pretty straightforward, so lets build this thing :D
LOLA DROID - DOWNLOAD HERE
https://drive.google.com/drive/folders/1pgycm5woAHDKORC_SNCbYlY4XJe2n0Pb?usp=sharing
Comments
Marko Makaj
Happy to hear that, i really am :)
Rick Sloss
Awesome thank you!! I will go check there! Thanks for all the work you do - my kids and I are so excited to print a lot of the models!
Marko Makaj
Are you on Facebook ? I posted photos in the group, and people shsre their builds in the group ss well. You will definstelly get more info there :)
Rick Sloss
Forgive me - I am a noob still. I see the parts are already orientated for the slicer - but what print settings should I go with to make sure they print well? Was thinking .15 layer height and 3 perimeters for the top / lower body parts. But would really appreciate if someone could offer some advice. Using Prusa Slicer and a Prusa MK3S+ with .6 nozzle. TIA!