bulkamancer
patreon
Zelda Updated
🕑 Added 2023-06-14 14:37:23 +0000 UTCHey friends,
A few people reported a number of small issues with the recent Zelda model, so we addressed them all (hopefully):
- Modified the right leg to resolve the issue known as "two left legs" .
- Changed the cut between face and hair (again) to reduce the chance of snapping the right hair strand.
- Eliminated a couple (very) tiny resin traps in hair and torso.
The files have already been updated both in Google Drive and on MyMiniFactory.
Cheers!
Des
Comments
Bulkamancer
The traps were less than 0.5mm thick and about 5mm wide, sitting 1-2mm below the surface. I'd say there are very good chances they are cured during post-processing.
Valentin Tumarkin
Thank you for the update! I already printed and started painting Zelda. How bad were the resin traps? Are they small enough to be cured in post-cure, or should I reprint?
