Kekreations 3D
patreon
Flexi Feather Dragon EARLY ACCESS
🕑 Added 2023-09-20 19:28:06 +0000 UTCHey everyone,
It's been a while since I've done a new flexi dragon, so it was well time for a new one! I've had this baby ready for AGES but kept pushing her off for other flexis people were voting on or holiday items that took priority. But she's finally here! She's a personal favorite of mine out of my dragon flexis so far.
Print recs
*3-4 walls
*15-20% infill
*Add a brim if you have adhesion issues
*Should print okay down to 80% size or so. Sized right now to fit average 220mm print beds but does well sized up when possible as well.
* No supports needed
Model link: https://www.kekreationsart.com/patreonmod
Refer to the pinned Patreon post here for the site password! (Once you use it once your device should remember it for next time) https://www.patreon.com/posts/3d-model-access-82725512
Hope y'all enjoy her!
Thanks so much for all your support <3
- Kek
