Kekreations 3D
patreon
Sleeping Dragon Box EARLY ACCESS
🕑 Added 2023-09-23 20:51:07 +0000 UTCHey everyone!
It's been a while since y'all have gotten a new box/container and I know y'all love them so here's a new one! This one has a sliding top where you can add some magnets to give it added security so you can toss it into a bag or box without worrying so much about it popping open. Also works perfectly well without the magnets too!
Print recommendations:
*2-3 walls
*10-20% infill
*Pictured is 0.2mm layer height, can print the lid at a smaller layer height for more detail
*Holes in the lid are designed to fit 5x2mm optional magnets. (There's a bit of wiggle room in the holes on most printers to allow for some added glue)
* Size up or down as desired but different size magnets would be needed if you want to use them
Model link: https://www.kekreationsart.com/patreonmod
Refer to the pinned Patreon post here for the site password! (Once you use it once your device should remember it for next time) https://www.patreon.com/posts/3d-model-access-82725512
Hope y'all enjoy this one!
Thanks so much for all your support!
- Kek <3
EDIT: Made a mistake with the upload and had 2 lids in there vs the body, but should be fixed now! Enjoy <3
