Kekreations 3D
patreon
Ouroboros Fidget Spinner EARLY ACCESS
🕑 Added 2023-08-28 19:53:10 +0000 UTCHey everyone!
New fidget spinner for this month :) The ouroboros spinner keychain! Had a lot of fun with this one and it's probably one of my favorite spinners now, the serpent eating it's tail made for the perfect round base for the spinner to feel nice in the hand.
Print recommendations:
- 2-3 walls
- 10-20% infill
- Prints with 4 lines across the bottom layer to keep the spinner middle from detaching from the bed. Snip those off when you get it off the bed.
- Photographed is 0.2mm layer height, you can print lower layers for better detail
Model link: https://www.kekreationsart.com/patreonmod
Refer to the pinned Patreon post here for the site password! (Once you use it once your device should remember it for next time) https://www.patreon.com/posts/3d-model-access-82725512
Hope y'all enjoy it!
Thanks so much for all your support! <3
- Kek
