my3dprintforge
patreon
December RENDERS + Voting Results
🕑 Added 2021-12-10 18:33:42 +0000 UTCGreetings guys!
I want to present you the final renders for December's release "Blood Elves".
The release consists of the following models (all pre-supported 32mm scale):
1. SpellBreaker Pose1 -standing with a weapon on the side
2. SpellBreaker Pose2 - standing with a weapon on the front
3. SpellBreaker Pose3 - Attacking
4. Lord Blood-Mage -caped
5. Lord Blood-Mage - Fire hand
6. Blood Mage casting fire
7. Swordsman with a book
8. Swordsman relaxed stance
9. Swordsman with a shield
10. Archer/Hunter
11. Archer on a Bird (mount)
12. Two Birds ( prints separately can be used as mounts)
13. Sorceress Flying
14. Sorceress casting Fire
15. Sorceress on a Bird (mount)
16. BUST -Lord BloodMage
17. BUST - Sorceress
18. BUST - Archer (weapon prints separately)
Please let me know in the comments what you think about this release and I would also like to know the top 3 miniatures that you like the most from this pack :)
My top 3 = Swordsman with a book, Archer on a Bird (mount), and Sorceress Flying :)
Again I went over my head with this release and here we are with 18 models! Really enjoyed sculpting these ones and I hope you like them as much as I do. ;)
Now working on pre-supporting and also need to test print.
I will do my best to deliver models this Sunday if I can.
Regarding Voting on the January release -Draenei won!
Expect some cool Draenai in January! :)
Cheers!
Comments
Thanks! I will try to make "gender equality" in the next release ππ
Fraser
These look awesome! My only nit of input would be that it would be great to have a little more female representation too rather than just the 1 - I think that was the same for the Forsaken too.
Thank you ! Happy to hear that you like them :) If you are going to post somewhere photos of prited/painted models please tag @my3dprintforge as I am always happy to see that and of course welcome to My3DPrintForge! π
LootPigeon
These look great! I only just came across your work on your Reddit post last night but Iβm going to go and grab a load from mmf. Been looking for a Kaelβthas (or proxy) for so long as a gift to my fiancΓ©. So model picks have to be 4,5 and 16. Now.. can I setup my 3d printer, print it and paint before Christmas or is it going to be a birthday present π
