mrbaddeley patreon

The 3 ring body design continues.. for the 500mm guys!

🕑 Added 2018-08-11 06:36:24 +0000 UTC

Comments

Kevin Volo

Where are these located on the onedrive. Awesome work

Timothy Hebel

I'd like to suggest making the data panel and charge bay panel backs as separate installable pieces. This makes the sanding and painting a lot easier as there would be less interior corners to navigate with a sanding block.

Joseph Masci

Me too I guess that I will have to cut these in half to be able to print them.

Peter Richards

I'm hoping this will be ready when my new dome finishes printing ;)

Michael Baddeley

They could be, yes :-)

Harold Harmon

Could these be sliced in quarters to fit on a 300mm bed?

Michael Baddeley

Thanks Peter, the lower ring is virtually there, got some work to do on the other two but getting closer.

Peter Richards

If you need anyone to test those files for you... :D

C.PZO

where in the folder is located? ha nvm. i just read that it is being tested.

Brendon Buhler

I really wish i made my diy printer 500 instead of 400, oh well

Yes it will. Each ring printed separately should fit nicely. I have printed 4 R2 domes on mine so far. All had plenty of room. The rings and the domes are the same diameter.

Will a CR-10-S5 able to print this ? i know build size is 500 x 500 x 500 but im not sure if its possible to use and print properly the entire print bed size