mrbaddeley patreon

Dome reworking

🕑 Added 2018-08-09 20:34:16 +0000 UTC

Comments

Terry Dossey

Oh - I almost forgot... I printed the dome pieces in PETG with 20% infil --- turned out amazing, again aside from those tiny supports. :) I wish the upgraded dome was available in 200mm.

Terry Dossey

Thank you Mike for developing the R7 dome, and splitting it for 200mm printers was awesome timing for us. R7 is our second droid, and the dome is amazing aside from cutting out all the tiny supports. I had to modify dome 8 because of the framing behind the four front logics, and the rib adjoining dome 1. . The framing would not allow me to install the RSeries logics. For starters, the RSeries logics were not designed to be installed close together, so I also had to modify those parts by cutting the ends off of the logics. The ribs that join dome 1 and dome 8 had to be cut out similar to dome 4-6, but in reverse. Meaning, the rib is not present nearest the front logic, but begins about 10mm above the top edge of the logics. I'm a beginner to Fusion 360, so I fought through Microsoft's 3D builder to remove the frames and modify. In the end, the object file is ugly, but it printed out what I needed to hopefully install the front logics without further modification.