tomstanton
patreon
Ebike 4.0 Rear Pulley
🕑 Added 2018-08-01 16:00:36 +0000 UTC This was a bit of a pain to fit due to the disk brake caliper being only 6-7mm from the wheel spokes. So the pulley has to squeeze between the spokes and the caliper, then bend back around the caliper to allow the belt to run past the tyre. On the plus side, the CNC is cutting aluminium very well!
Comments
Tom Stanton
It's pretty close haha!
Logan Vinson
Incredible!
Tom Stanton
<img src="https://c10.patreonusercontent.com/4/patreon-comment/eyJ3IjoxNjAwfQ%3D%3D/whWu5AZjQgvYwvb13XOKR8rHkiDEOGJFz2aMsYlWqwVNXQ67CiQNJpViQGlI9xnN.jpg?token-time=1701388800&token-hash=6oTDwMfl17MaqC3C3qdldBXPlJSt-mxXetz_RCMmmtA%3D">
Tom Stanton
Tom Stanton
<img src="https://c10.patreonusercontent.com/4/patreon-comment/eyJ3IjoxNjAwfQ%3D%3D/PIdJP2W03I4vrcUCFdoFK5z8SWDdLVy_moMfpAVMYaz0GsLn3r6ODkIB3JefIjLG.jpg?token-time=1701388800&token-hash=jcCXJDZnwDMvzDTwF2hCzkSFgkbDUp5ObU4Wt0JR91U%3D">
Logan Vinson
Regardless, congrats on squeezing that into such a tight place!
Logan Vinson
How are your clearances? Did the caliper allow for enough play?
