moid
patreon
Rolling Wall: latest files
🕑 Added 2022-12-03 02:24:59 +0000 UTCHELLO AGAIN! The fix I made worked great I re-print all pieces and now I can assure you that the supports on my side worked 100%.
I did a lot of many test prints, to find any issues and the best settings. It took me almost 3 Liters of resin making all this tests.
You will find the the latest files on this post: Rolling Wall Assault Tank
Here is a preview of my preassembled tank, (Sorry for all the dust, I hand sanded the Tire Tracks)
For the print sets I highly recommend that you Divide the different STLs in to 2 groups. Large and Small
You should send all the small bits in a same build plate.
And the Large pieces separately from the small pieces.
I used Siyaratech fast Navy blue resin.
Most important settings I tweak where the Lifting speeds and Light-off delay, to avoid the STLs to fall from their supports, and or Layer shifting lines, because some pieces are huge.
My settings where:
Light-off Delay: 3s
Bottom Light-off Delay: 9s
Bottom Lift Distance 7mm
Lifting Distance 7mm
Bottom Lift Speed: 45mm/min
Lifting Speed: 45mm/min
Retract Speed: 150mm
Comments
Almost finish, I'm on them right now, thanks for your patience.
Looking forward to the smaller printer fix, then I'll get this puppy started :D
