ForgeCore
patreon
Nintendo Switch Storage Spinner (Green Tube)
🕑 Added 2024-02-03 20:46:15 +0000 UTCThis switch games storage spins in a super satisfying way! It is inspired by that popular video game you may have heard of with green tubes (;
Selling Opportunity! A version of this that DOESNT EVEN SPIN sells on Etsy for $30. So this could be a very profitable item even with the bearing and magnet cost.
Components you'll need.
1. The Magnets: Small Round Magnets (Amazon) (same magnets as all other prints)
You'll need 22 magnets per spinner
2. Bearings: Fidget Spinner Bearings (Amazon)
You need just 1 bearing per spinner
3. Stick on Rubber Base (Optional): 58mm Anti-Slip Silicone (Amazon)
You need just 1 per spinner
Comments
ForgeCore Co
The magnets have no affect on the games. Switch cartridges don’t use magnetic memory and will not be affected.
Jose
Hello! A question I have about the spinner tube files for Nintendo Switch games. The magnets don't damage the game chips, is the switch? thank you.
ForgeCore Co
Oh that’s super long, what printer are you using?
What kind of average print time are you all seeing for this with the recommended settings? I'm getting 10 hours on the base and 10 hours on the top
SkysThLimit
Any chance you can share your support settings on this one? I'm having some trouble with it
TX911GUY
What did you use for the interface material?
ForgeCore Co
Hi! Did you try tapping it in with a hammer or mallet? It can take some force
Sherris
the bearings do not fit into the cap, impossible to assemble
Kyle Weiss
I really love this design and just sold my first one of it! Also, I did find using pla support filament makes printing the top super clean. Flip over, support interface the support filament, came out as one big chunk.
ForgeCore Co
Yup exactly the same
All of the parts needed to purchase for this model are the same as the red one correct?
ForgeCore Co
It wont be able to print without supports, you may need to adjust your support settings, mine came right off. You make need to adjust your gap between the supports and model of you’re having a hard time removing it
TX911GUY
Yeah, trying to remove the fine mesh layer on the top is a pain…did you try printing without supports?
