ForgeCore
patreon
Aloe Vera Pen Plant
🕑 Added 2024-03-20 22:19:57 +0000 UTCThis Aloe vera Pen Plant makes the perfect addition to a desk. It keep your space lively and green but each stem also serves as a pen!
The stems magnetize onto the base, and each stem has a pen refill inside of it so you can write with them!
Components You'll need to order
1. The Magnets: Small Round Magnets 5x3mm (Amazon) (same magnets as all other prints)
You'll need a total of 40 magnets. 2 per each stem, and 2 per each stem attachment. Don't worry, they aren't that expensive!
2. The Pen Refills: 0.7mm x 107mm ballpoint pen refills (Amazon)
Assembly:
Each Plant requires
1 Base
2 of Stem A
2 of Stem B
2 of Stem C
2 of Stem D
1 of Stem F
1 of Stem G
-Insert magnets into the base of the stems, and into the holes on the base.
-Insert Pen refills into stems, make sure to align notch on pen.
-Repeat for each stem.
Filament Used:
Green Plant Color: Ziro Matte Military Green Grey
Dot Color: Polyterra Matte Muted Green
Comments
Jessica Jennings
Hello! I do not see the file for G listed? Above it says we need one F and one G file.
Spirit
the leaves load into the slicer at .1 mm long and half a millimeter in thickness, what do i have to scale them to, i have had this issue with every plant model you have across 3 different slicers
Josh Kaminski
This was a fun print, just waiting on some Terracotta PLA to come in for the Pot!
